About this lab
Three lessons: the landforms ice leaves behind, the water level after ice melts, and the shoreline changes made by waves moving sand.
A glacier is more than a slow river of ice. It abrades and plucks the valley walls and floor, and when it retreats it leaves a U-shaped valley with a wide floor, hanging tributary mouths, cirques and arêtes, and till in which grains of every size are mixed and unsorted. A coast is not a fixed line either: waves run obliquely up a beach and push the sand a little way along the shore; block it, and sand piles up upstream and erodes downstream; raise the sea, and a gentle beach retreats far while a steep rocky shore retreats little.
The valley and the coast are invented teaching scenes and are not any real place. The ice amount, wave direction, slopes and the numbers for the beakers are teaching values, and every reading on screen comes from one model. Longshore transport and shoreline change are teaching simplifications, used to compare direction and size, and they predict no real coast.
Three results
Three results
- Glacial landforms: a valley cross section can be written z = floor + depth × (|x| ÷ half-width)^b. A V-shaped valley cut by a river has b = 1; a U-shaped valley ground out by ice has b of about 3.2. At half depth the U-shaped valley is 0.69 of the width at the shoulder and the V-shaped valley only 0.44, and the floor widths differ six-fold. A hanging valley whose mouth lies about 250 m above the main floor, and unsorted till (sorting coefficient σI about 3.6 φ against about 0.8 φ for river gravel), are two further kinds of evidence. A U-shaped outline alone cannot settle the origin, because a glacier can also reshape an old river valley.
- Land ice and sea ice: floating ice displaces water with a mass equal to its own, so when it melts the level in a fresh-water beaker stays exactly the same. Ice resting on land adds new water when it melts: 20 g of ice becomes 20 cm³ of water, the water surface is 50 cm², and the level rises by 20 ÷ 50 = 0.4 cm. Ice in salt water displaces denser water and turns into fresh water, so the level rises slightly, by about 0.01 cm. Water also expands when it warms: 100 mL warmed from 20 ℃ to 35 ℃ rises about 5 mm in a narrow neck, which cannot be seen in a straight-walled beaker.
- Coastal change: the longshore rate is Q = Q₀ sin 2α, where α is the angle between the wave crests and the shore, and reversing the waves reverses the transport. A groin stops the transport: the shoreline advances on the upstream side and retreats on the downstream side, each by about 109 m after 10 years, with equal volumes of sand on both sides. When the sea rises by ΔS the shoreline retreats by ΔS ÷ slope: for 10 cm, a beach with slope 1:30 retreats 3 m and a rocky shore with slope 1:2 retreats only 0.2 m.
Model and sources
Model and sources
- The valley terrain is an analytic function: the main cross section uses a power law, the ice surface is the highest of the ice-surface elevations of the separate glaciers, and the thickness is the ice surface minus the bedrock, so the ice margin retreats monotonically as the ice amount falls. Valleys, cirques and the massif are joined with a smooth minimum; all of this is an invented teaching scene. The grain-size distributions are invented teaching samples too, and the sorting coefficient follows the graphic standard deviation of Folk and Ward 1957, σI = (φ84 − φ16) ÷ 4 + (φ95 − φ5) ÷ 6.6; σI between 1.0 and 2.0 is poorly sorted and between 2.0 and 4.0 very poorly sorted.
- The melting experiment uses conservation of mass and buoyancy: ice has a density of 0.917 g/cm³, fresh water 1.000 g/cm³, and surface sea water (35 g/kg) 1.025 g/cm³ (illustrative). The stone in beaker B stands out of the water, so the water surface is the beaker section of 62 cm² minus the stone section of 12 cm², which is the 50 cm² of the report. The ice melts as a sphere, and the cube root of its volume falls linearly with time. Thermal expansion uses the EOS-80 density of pure water (998.21 kg/m³ at 20 ℃ and 994.03 kg/m³ at 35 ℃) and subtracts the expansion of the glass. This is an ideal calculation that ignores temperature changes, evaporation and loss of meltwater, and it does not claim that melting real sea ice has absolutely no effect on sea level.
- The coast uses a CERC-type longshore transport formula Q = Q₀ sin 2α (Q₀ = 60000 m³ per year, a teaching value) and a one-dimensional shoreline model (one-line model). Shoreline change at the groin follows the Pelnard-Considère analytic solution: displacement y = ± tan α × 2√(Gt) × ierfc(|x| ÷ 2√(Gt)), with G = 2 Q₀ cos 2α ÷ D and D = 8 m the active profile height. Linearising makes the accumulated volume about 7% smaller than Q·t. Retreat from sea-level rise uses the geometric relation R = ΔS ÷ tan β and leaves out redistribution of sand and other changes to the coastline. The wave phase table follows the linear dispersion relation and Snell's law, and the wave amplitude is drawn about 2 times larger.
- Coastal Wiki · Littoral drift and shoreline modelling ↗ Longshore transport and the one-line model, checked 2026-11-17
- Coastal Dynamics (Bosboom and Stive) · Bulk longshore transport formulations ↗ CERC formula, checked 2026-11-17
- Engineering ToolBox · Water density and specific weight ↗ Water density at 20 ℃ and 35 ℃, checked 2026-11-17
- DSDP Volume 27 · Grain-size distribution of sediments ↗ Folk and Ward sorting classes, checked 2026-11-17