About this lab
Three experiments, one thread: a map is the ground drawn smaller to scale; the scale turns map lengths into real ones, length and speed give time, and when conditions change, the best route changes too.
The scale turns lengths on the map into lengths on the ground, the north arrow shows which way is north, and the legend says what each symbol means. A route is not judged by length alone: of two 700 m routes, the one over the hill takes 6.67 min longer, and the nearest bridge is the first thing to flood.
The sand table, pond, bridge and water levels are original teaching data, not any real place. The lengths and walking speeds of the four roads come from the research report. The sand table is at true scale; the hill has not been stretched upwards.
Three results
Three results
- Scale: on a 1:10000 map AB is 3 cm, which is 300 m on the ground, not 30 m. Print the whole map twice as big and AB measures 6 cm, so the scale must become 1:5000; leave it unchanged and you get 600 m. The scale bar grows with the map and stays correct. A frame of the same size holds only a quarter as much ground at 1:5000 as at 1:10000. Turn the north arrow to point right and the right of the sheet is north: B is due north of A.
- Time: A–B–D and A–C–D are both 700 m. The first takes 11.67 min; the second climbs the hill and takes 13.33 + 5.00 = 18.33 min. Averaging 30 m/min and 60 m/min to 45 m/min is wrong; it gives 15.56 min. A 500 m bridge takes only 8.33 min. The 400 m for AC is a straight line measured with a ruler; a string laid along the bends gives 477.78 m, or 20.93 min of walking.
- Closures: at 4 m the water covers the 3.5 m bridge deck and the fastest route goes back to A–B–D. At 6 m it covers the lowest point of BD (4.98 m), leaving only A–C–D over the hill. At 7 m it covers the lowest point of CD (6.40 m): D itself stays dry, but no open road leads to it, so no route is possible. With a queue of more than 3.33 min at the bridge, the bridge is slower than A–B–D even without a flood.
Model and data
Model and data
- Ground length = map length × scale denominator, converting cm to m first. Bearing = direction on the paper − angle the north arrow is turned, both measured clockwise from the top of the sheet.
- Route time is worked out by section: the time of each section = length ÷ that section’s speed, then added. The fastest route is found with Dijkstra’s algorithm on open roads only; the self-check confirms it by listing every possible route.
- Water uses a still-water model: the surface is level across the whole sand table and everything lower is under water; a road closes as soon as its lowest point is covered. It does not model how water flows in or how fast, so it is not a flood forecast.
Route lengths are horizontal distances; the extra length along a slope is not counted. A real evacuation also depends on road capacity, exposure to danger and congestion, which are not in this model. The queue times at the bridge are teaching data set up for comparison.
Back to geography ↑